Computer Vision vs RFID · Visual Verification

RFID reads a tag.
Zimark verifies the pallet.

Your WMS believes what it was told. RFID only confirms a tag passed a reader. Zimark verifies every pallet by sight, on your forklifts and at your dock, and captures video proof, closing the gap between what your system says and what actually happened on your floor. No electronic tags, no readers, no RF infrastructure: it works with the labels and pallet IDs you already use.

Book a Discovery Call

Backed by ZIM (NYSE: ZIM)

VERIFIED · PLT-4821

Load complete · 24/24 pallets

Proof of Load · Dock 04 · 2:14 PM

Forklift moving a pallet on the warehouse floor

The Gap RFID Leaves

A Tag Read Is Not Proof of What Actually Happened.

Your system is only as accurate as the last thing someone scanned. RFID doesn't fix that; it just adds one more signal to trust. It confirms a tag crossed a reader, not that the right pallet is in the right slot or on the right load. And it leaves you nothing to show when a customer disputes a shipment.

It Can't Confirm the Load

A portal reads that a tag passed a door. It can't see which pallets actually made it onto that shipment, so misloads sail through with a clean log.

It Can't Confirm the Slot

A tag says a pallet exists, not whether it is in location 3B-12 or three aisles over. Your WMS keeps drifting, and the cycle counts never stop.

It Leaves No Evidence

RFID gives you an electronic log, not a picture. When a claim lands, you have nothing visual to settle it.

Computer Vision vs RFID

Two Ways to Chase Accuracy. One Actually Proves It.

Both promise fewer errors. The difference is what they verify and what they leave you holding when a customer disputes a load.

At the Dock and on the Floor

RFID

Visual Verification

What it actually confirms

A tag passed a reader

The right pallet, seen on camera

Proof you can share with a customer

An electronic log, no visual record

Shareable video of every load and move

What goes on each pallet

An electronic tag on everything; supplier compliance required

The labels you already print, with a small added marker

Right pallet, right load?

Confirms a tag passed a door

Checks every pallet against the shipment at the door

Right pallet, right slot?

Confirms a tag exists, not where it sits

Confirms the pallet is where the WMS says it is

Near metal and liquids

Reads degrade (RF interference)

Unaffected: it's vision, not radio

Infrastructure to install

Readers, antennas, dock portals, middleware

Cameras on your existing forklifts and dock doors

Resolving a freight claim

Hunt the log, argue with the customer

Pull the video, share it. 45× faster

Where RFID still earns its place: reading individual SKUs inside sealed, shrink-wrapped cases, or meeting a retailer RFID mandate (Walmart, Target). Zimark verifies at the pallet level, with visual proof, and the two can run side by side.

How It Works

Live in Days, on the Forklifts You Already Run

Keep the Labels You Already Print

Zimark integrates directly with your label printers and adds a small black-and-white marker to the labels you already use. No electronic tags, no readers, no new consumables.

Let the Cameras Do the Watching

Cameras on your existing forklifts and dock doors automatically capture every pallet move and every load. Staff don't change how they work.

Verify, Prove & Sync

Zimark verifies each pallet by sight and saves the video. Keep your WMS accurate with no integration needed to start, and add one-way or two-way sync when you want it.

What Changes

Accuracy You Can Prove. Hours You Get Back.

99.999^%

loading accuracy (Five-9s)

45^×

faster claim resolution vs manual CCTV

95^%

less time searching for lost pallets

30^%

more loading capacity

2+^hrs

saved per dock, every day

Figures from Zimark deployments.

Savings Estimator

See What Accuracy Is Worth, in Three Questions.

Answer three quick questions about your pallet volume, error rate, and labor, and get a savings estimate for your own warehouse. No call required.

1 · Pallets shipped per week 2,500

2 · Shipping error rate 0.5%

3 · Hours per day on cycle counts, CCTV review & pallet searches 3.0 hrs

Assumes $350 average cost per shipping error and $28/hr loaded labor. Prevention and time-recovery rates from Zimark deployments.

Estimated Annual Savings

Shipping errors prevented (0/yr)$0

Labor hours recovered$0

Calculate My Payback on a Call

Proof of Load · Dispute Defense

When a Customer Disputes a Load, Win It in Seconds.

Every pallet isn't just verified, it's videoed, indexed, and saved. Search by pallet ID or shipment, pull the clip, and share it in one click. RFID can't hand you that.

Shareable proof of load for every shipment

Indexed by pallet, shipment, and timestamp

Walk into every dispute with the footage, not excuses, and protect the customer relationships one bad load can cost you

Indexed visual proof of load for shipment BOL-30412

PROOF OF LOAD · SHIPMENT BOL-30412

Pallet PLT-887412 · Dock 04 · 2:14 PM

Clip found · ready to share

Share Clip

Stakeholder Ready

Built to Clear IT and Finance

You already know it works on the floor. Here's what your IT and finance stakeholders will ask first.

For IT

A Lightweight Layer, Not a Replacement

Works alongside your existing WMS with no integration required to start; one-way or two-way when you want it

Runs on the forklifts and dock cameras you already own

No RF readers, antennas, or portals to tune and maintain

Top-of-industry information security; data handled to your standards

For Finance & Ownership

The Math Works Without Per-Tag Cost

No per-tag consumable, no reader or middleware capex

Fewer chargebacks, OTIF fines, and detention charges

Staff off cycle counts and CCTV review, onto real work

Model your payback on your own error and labor numbers

Proof From the Floor

Warehouses Are Achieving More With a Lot Less

"Automated shipping control ensures 100% accuracy in loading, eliminating errors completely. Our entire loading process is fully documented, giving us instant access to visual proof of every shipment."

Chaim Hod

Bonded Manager, Millennium Group

"Zimark's solution is not only cost-effective and easy to use, but offers immediate ROI that far exceeds entry-level automation. Zimark doesn't just keep up with technology change, it leads it."

Daryl Lester

President, Adaptive Logistics

FAQ

What Ops Teams Ask Before Choosing Vision Over RFID

Is this just RFID with cameras?

No. RFID reads a radio tag and trusts it. Zimark uses computer vision to confirm the actual pallet is present and correct, then saves the video as proof. You verify what happened, not what a signal suggests.

Do I have to tag every pallet?

No electronic tags. Zimark prints a small black-and-white marker onto the labels you already use, through your existing printers. No chip, no reader, no supplier-tagging program, and no per-pallet consumable to buy.

Will it work with my WMS?

Zimark is WMS-agnostic. Many teams start with no integration at all and still get verification and proof. When you're ready to sync, if your WMS has an API or file export, we can work with it, one-way or two-way. Integration effort varies by WMS vendor, and we'll tell you upfront what yours involves.

Does it work near metal and liquids?

Yes. Because it's vision, not radio, Zimark isn't affected by the metal and liquid interference that degrades RFID reads.

Is this GPS tracking?

No. Zimark verifies pallets inside your four walls, at the dock and on the floor, for loading and inventory accuracy. It does not GPS-track shipments once they leave the building.

Can it tell me if a pallet is damaged?

Zimark gives you the video and images to inspect condition yourself; it does not automatically flag damage. You get the evidence; your team makes the call.

Final Call

See What Your Cameras Already See

Book a 20-minute discovery call. We'll show you visual verification on real shipments and find the accuracy gap RFID can't close. If we're not a fit, we'll tell you.